With two IP addresses on the same network card, the computer stays online using your network IP and accesses the NEOiD camera through a second IP, in the camera’s factory range. The step-by-step is done in Windows and applies to the models listed below.
Factory IP and login for each model:
NEOiD PTZ USB PRO G2, NEOiD PTZ USB PRO 4K, NEOiD PTZ NDI 20X G2, NEOiD PTZ NDI 30X G2 and NEOiD PTZ NDI 4K:
192.168.100.88, useradmin, passwordadmin.NEOiD ROLEPLAY 4K:
192.168.100.99, useradmin, passwordadmin.NEOiD PTZ NDI 4K PRO:
192.168.1.188, useradmin, passwordadmin.NEOiD PTZ 4K BROADCAST, NEOiD PTZ ULTRA 4K and NEOiD PTZ ULTRA 4K 1″:
192.168.100.88, userneoid, passwordneoid.
The network already has wired internet access.
You use a switch or router.
The camera is physically connected to the same network as the computer.
Press Windows + R and type
cmd.Run the command
ipconfig.In the Ethernet adapter section, write down the IPv4 address, subnet mask, and default gateway (for example,
192.168.1.44,255.255.255.0and192.168.1.1).
Press Windows + R and type
ncpa.cpl.Right-click the Ethernet connection and open Properties.
Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.
Select Use the following IP address and fill in with the values you wrote down in step 1.
Click Advanced.
In the IP addresses tab, click Add.
Enter a second IP in the camera range (see your model’s factory IP above), with mask
255.255.255.0:range 192.168.100.xxx: for example,
192.168.100.144(gateway192.168.100.1);range 192.168.1.xxx: for example,
192.168.1.144(gateway192.168.1.1).
Click Add and then OK in all windows.
Open the browser (Chrome, Edge, Firefox or another) and type the camera IP.
Log in with the username and password for your model (see the list above).
The computer keeps one IP for the internet and another to talk directly to the camera.