This step-by-step guide updates the firmware of NEOiD cameras that use the old web interface (WebUI), through the SYSTEM → Online Update menu. Check below if it applies to your model and to the installed firmware version.
NEOiD PTZ NDI 4K: only up to firmware V0.0.36.
NEOiD PTZ 4K BROADCAST: only up to firmware V8.1.11.
Above these versions, NEOiD PTZ NDI 4K and NEOiD PTZ 4K BROADCAST use a different process: see How to update the firmware of NEOiD PTZ NDI 4K and PTZ 4K BROADCAST with the new WebUI. For NEOiD PTZ NDI 4K PRO and PTZ ULTRA, see How to update the firmware of NEOiD PTZ NDI 4K PRO, PTZ ULTRA 4K and PTZ ULTRA 4K 1″. If your model is not listed, contact support.
Read the entire procedure before starting: an incorrect update may cause equipment failures.
Use the camera’s original (DC) power supply.
Do not disconnect the network cable and do not turn off the camera during the update.
Keep the network and IP stable.
Do not move the camera by hand and do not use the remote control.
Keep the camera and the computer on the same network.
Identify the model through the invoice, the label on the box, or the label under the camera.
In Downloads, open your camera’s page (View product) and download the firmware marked as Última (Latest).
With the camera and the computer on the same network, type the camera’s IP in the browser:
192.168.100.88by default,192.168.100.99on NEOiD ROLEPLAY 4K, or the IP you configured.Log in to the camera:
admin/adminon most models andneoid/neoidon NEOiD PTZ 4K BROADCAST.In SYSTEM, open Online Update, select the downloaded firmware and start the update.
In the confirmation message, click OK. The camera will perform automatic movements: do not interrupt.
Mandatory: in SYSTEM, restore the camera to factory defaults. Without this, the update will not finish correctly.
If you use an IP different from the default, configure the network address again.
The update takes about 5 minutes and finishes when the camera stops the automatic PTZ movements and responds again via IP.