This step-by-step guide updates the firmware and patch of NEOiD PTZ NDI 4K and NEOiD PTZ 4K BROADCAST that already use the new web interface (WebUI), via the SYSTEM (SISTEMA) → Maintenance menu.
NEOiD PTZ NDI 4K: from firmware V0.0.37.
NEOiD PTZ 4K BROADCAST: from firmware V1.13.
On NEOiD PTZ NDI 4K up to V0.0.36 and on NEOiD PTZ 4K BROADCAST up to V8.1.11, the process is different: see How to update the firmware of NEOiD cameras with the old WebUI. If your model is not listed, contact support.
The screens may change depending on the installed version. This step-by-step guide was made with NEOiD PTZ NDI 4K on firmware V0.0.39 / patch V1.3.4 and with NEOiD PTZ 4K BROADCAST on firmware V1.13 / patch V1.3.2.
Read the entire procedure before starting: an incorrect update can cause equipment failures.
Use the camera’s original (DC) power supply.
Do not disconnect the network cable and do not turn off the camera during the update.
Keep the network and IP stable.
Do not move the camera by hand and do not use the remote control.
Keep the camera and the computer on the same network.
Identify the model using the invoice, the label on the box, or the label on the bottom of the camera.
In Downloads, open your camera’s page (View product) and download the firmware and patch marked as Última (Latest).
With the camera and computer on the same network, type the camera’s IP in the browser:
192.168.100.88by default, or the IP you configured.Log in with the camera credentials:
admin/adminon NEOiD PTZ NDI 4K andneoid/neoidon NEOiD PTZ 4K BROADCAST.
In SYSTEM (SISTEMA) → Maintenance, click Select file and choose the firmware.
Read the notice and click Close.
Click Upload and then Confirm.
Wait: the camera will move automatically and show the Firmware installation message until the end. Do not interrupt.
Then the page reloads and asks for the username and password again.
Log in to the WebUI again with username and password.
In SYSTEM (SISTEMA) → Maintenance, click Select file and choose the patch.
Click Upload, then Install, and confirm.
The patch installs in about 10 seconds and the page refreshes automatically.
Mandatory: in SYSTEM (SISTEMA) → Maintenance, click Restore factory defaults and confirm. The camera will start the restoration automatically.
If you use a different IP from the default, configure the camera’s network address again.
The update takes about 5 minutes and ends when the camera stops the automatic PTZ movements and responds to the IP again.