This step-by-step guide updates the firmware of NEOiD PTZ NDI 4K PRO and NEOiD PTZ ULTRA via the web interface (WebUI), under Manage → Firmware Upgrade. The package contains the FPGA, ARM, ISP and LOGO (plugin) files, which must be uploaded in a fixed order.
NEOiD PTZ NDI 4K PRO: the package may or may not include the FPGA, depending on the hardware version.
This procedure applies only to these models. For other NEOiD cameras, see How to update the firmware of NEOiD cameras with the old WebUI or How to update the firmware of NEOiD PTZ NDI 4K and PTZ 4K BROADCAST with the new WebUI.
Read the entire procedure before starting: an incorrect update can cause equipment failures.
Use the camera’s original (DC) power supply.
Do not disconnect the network cable and do not turn off the camera during the update.
Keep the network and IP stable.
Do not move the camera by hand and do not use the remote control.
Keep the camera and the computer on the same network.
Identify the model from the invoice, the label on the box or the label under the camera.
In Downloads, open your camera’s page (View product) and download the firmware marked as Última (Latest). The package contains FPGA, ARM, ISP and LOGO (plugin). Save the files on the computer.
With the camera and computer on the same network, type the camera’s IP in the browser:
192.168.1.188for NEOiD PTZ NDI 4K PRO and192.168.100.88for PTZ ULTRA, or the IP you configured.Log in with the camera credentials:
neoid/neoidon PTZ ULTRA andadmin/adminon NEOiD PTZ NDI 4K PRO.
Under IP Settings → Audio Settings, enable Audio Status.
Under Camera Settings → System Mode, choose
Full NDI PRIORIDADE.Go back to IP Settings → NDI® High Bandwidth and check that it is enabled.
Check that the camera’s main IP and the Full NDI® IP are on the same subnet, without conflicts.
Open Manage → Firmware Upgrade.
Upload the files in this mandatory order:
FPGA
ARM
ISP
LOGO (plugin)
If you use a different order, the update may cause equipment failures.
The camera will perform automatic movements: do not interrupt.
Mandatory: under Manage → System Management, perform a factory reset.
Clear the browser cache.
Log in to the WebUI again and check that the firmware version is updated.
If you use a custom IP, configure the network address again.
The update takes about 5 minutes and ends when the camera stops the automatic PTZ movements and responds again via IP.
In the WebUI, the firmware version should appear updated.
If the update fails, perform a factory reset and repeat the entire process. If the error persists, contact technical support.